M
AINTENANCE
ProStar 335 Photodiode Array Detector
105
Figure 37 Fuse compartment and two fuses either side
3. Check that the fuses are the correct type and are not
damaged. If necessary, replace them.
4. Replace the fuses back in the red fuse holder. Push the
holder back into the mains input connector and then lower
the cap.
5. Reconnect the instrument to the mains power supply.
NOTE:
If a fuse blows repeatedly, it may indicate other problems with the
instrument. A service call may be required.
Cleaning the instrument
The exterior surfaces of the ProStar 335 detector should be kept
clean. All cleaning should be done with a soft cloth. If necessary,
this cloth can be dampened with water or a mild detergent. Do
not use organic solvents or abrasive cleaning agents.
