74
85-102113-00:1
Installing the door
The module door may be attached to the front of the ProStar 335
detector to cover the tubing connections to the flowcell.
Installing the door cap
If the ProStar 335 detector is the top module in the stack, the
door cap should be installed before installing the door on the
module.
If the ProStar 335 detector is not at the top of the stack, do not
install the cap and proceed to the instructions describing door
installation on page 75.
To install the door cap:
1. Stand the door upside down on a flat surface (i.e. with the
two ‘ribs’ towards the bottom, refer to Figure 15).
Figure 15 Inserting the door cap onto the ProStar 335 door
Ribs
Door cap
Magnetic latch
