I
NSTALLATION
ProStar 335 Photodiode Array Detector
75
2. Take the cap and remove the protective paper exposing the
adhesive that will secure the cap to the door.
3. Insert the cap into the door and press the adhesive onto the
inside of the door lip. Be sure to keep the door edges and
cap edges flush (refer to Figure 15).
Installing and removing the door
To install the door:
1. Insert the top hinge pin into the top hinge.
2. Gently press down on the top of the door (refer to Figure 16)
and slide the lower hinge pin into the lower hinge. The door
should now pivot on the pins and close. The magnetic door
latch should stick to the instrument.
Figure 16 Installing the ProStar 335 door
