30
03-914875-00:1
When a program is selected, it is necessary to specify whether it
should be modified or a new program should be created.
MODIFY=0, NEW=1
0
Numeric key
→
Enter key
Set up the time program
The first line of the time program is indicated below.
TIME Ex Em BASE (A/Z=1, HOLD=2)
0.0 250 350 1
Enter the appropriate time (the time for the first line is fixed at
0.0) and press Enter to place the cursor in the Excitation
Wavelength field. Enter the desired excitation wavelength and
press Enter to place the cursor in the Fluorescence (Em) field.
After the fluorescence wavelength is selected, the cursor will
appear in the BASE field. Enter 1 to indicate if the Auto Zero
feature should be used to reset the baseline or enter 2 to
indicate if the present level of the baseline should be maintained
when the wavelength is changed.
NOTE 1:
In the time program, the 'TIME’ for the first step is 0.0, which
cannot be changed or deleted. After this step has been edited,
the time field for the second step can be accessed by using the
key. At this point, any time up to 600.0 minutes can be
used. Continue to enter lines. The time program can be
carried out until the end-of-measurement time specified at the
last step is reached.
NOTE 2: The time interval between lines should be at least 0.3 min.
Cursor
movement
Summary of Contents for ProStar 363
Page 2: ......
Page 6: ...iv 03 914875 00 1...
Page 20: ...14 03 914875 00 1...
Page 82: ...76 03 914875 00 1...
