3
Installation of the mixer:
Install the machine so there is workspace for normal use
and maintenance.
The floor of the workspace where the machine is installed
must be firm, even and level.
The mixer must be mounted with rubber feet, that eliminate
both shaking and rusting. If the floor is not completely even,
spacers can be inserted under the mixer’s feet to ensure
the machine is level.
Foundation bolts in the floor are only necessary under
special conditions, e.g. on ships.
The ambient temperature around the machine must not
exceed 45
ºC
Connection to power:
The mixer is to be connected to power via a
plug. The plug must be dimensioned for min.
16 A, 230/400V~, IP44
When connecting;
3 earth, use a 4 pole plug.
3 phases with 0 + earth, use a 5 pole plug.
Before the mixer is connected to power, it should be
checked that the voltage and frequency printed on the
machine label is correct in relation to the place of instal-
lation. The machine label is located on the top right side
of the mixer.
Commissioning:
Machine, bowl, tools safety guard and filling chute must
be cleaned before use – see section on Cleaning, page 4.
Safety:
The mixer may only be used, cleaned and maintained by
trained personnel over 14 years of age. Always observe
local laws and regulations, paying particular attention to
the operator’s age, physical and mental condition.
The constant noise level of the workplace of the operator
is lower then 70 dB (A)
The mixer is designed for commercial use in kitchens,
catering outlets and bakeries.
The mixer must not be used in an explosive atmosphere.
The mixer may only be used as specified in this manual.
The mixer is designed for manufacture of pro-
ducts which do not during processing cause
reactions or emit substances which may be
detrimental to the user.
Putting your fingers in the bowl while the mix
-
er is running may cause injuries.
Electrical connection must only be carried out
by a certified electrician.
Lifting equipment should always be used to
move the mixer.
When the mixer is moved, it should be in an
upright position at all times.
(VL-1, VL-1L)
The mixer must not be pulled or
lifted by the bowl lift handle and speed selec-
tion handle.
Powdery ingredients:
Do not pour powdery ingredients into the
bowl from a great height.
Bags of e.g. flour should be opened at the
bottom, down into the bowl.
Do not increase to maximum speed too quickly.
Warning for users with implants (e.g. pacemakers, defibrillators etc.)
Mixer and safety guard are equipped with strong magnets.
Area with magnets
Safety guard.
Area with magnets
Bowl detection
.
Area with magnets
Safety guard.
