14
Error codes shown on the display:
OL:
The motor protection relay has stopped the machine and
is shown in the display for ‘overload’
• Allow the machine to cool down.
• If the machine does not change to normal mode, the relay has to be manual reset .
• See section “Manual reset of motor protection relay” on page 15.
EE1:
If the bowl is not in the correct position when the Start button is pressed,
will appear on the display.
• Place the bowl in the cradle. Raise cradle and bowl to the correct position.
EE2:
If the safety guard is not fitted correctly or closed when the Start button is pressed,
will appear on the display.
• Check that the safety guard is closed correctly.
EE6:
If the machine display shows
when the Start button is pressed, it means the start relay was not activated correctly.
• Contact a technician to check the start relay.
List of errors:
(In case of other errors, contact the supplier.)
Possible solution:
A rattling sound from the closed part of the mixer.
Adjustment of special V-belt
"The mixer starts “striking” when kneading dough
which normally causes no problems."
Adjustment of special V-belt
The mixer changes its speed by itself.
Adjustment of special V-belt
The minimum and the maximum speeds are changing.
Adjustment of speed.
The bowl is too tight or too loose.
Adjustment of bowl fixing
The tool hits the sides of the bowl.
Adjustment of bowl centring
The tool hits the bottom of the bowl.
Adjustment of bowl height
Electrical Fuse (VL-1):
The machine is protected by a fuse. The fuse is built into the back
of the control panel.
