Varimixer KODIAK V20KT, Operating Instructions And Spare Parts Lists

5

1

2

31

7

/

64

”

Transport:

Lifting equipment should always be used to move the machine.
The machine must not be pulled or lifted by the bowl lift handle.
When the machine is moved, it should be in a vertical position at all times.

Installation, adjustments and securing: 

The ambient temperature around the machine must not exceed 113

o 

F.

Especially for  floor model - Adjustments:

The height of the legs should be adjusted

 so that the bowl on the bowl trolley 

fits perfectly into the bowl arms.
The bowl arms should be at the correct height above the floor before the machine 

is taken into use – see

 “

Condition 1” and Condition 2.

It is of the utmost importance that the machine’s legs are adjusted so that the 

conditions described by the following sketch are met:

Condition 1:

The top of the mixer must be parallel to the floor. To ensure this you must measure the distance from the top of the machine 

to the floor:

The dimension must be the same when measured at the front of the mixer 

and at the rear of the mixer: 

Condition 2

The mixer must be height adjusted so that the bowl on the bowl trolley fits exactly in the bowl arms:
Basically, the dimension from floor to center of the knobs on the bowl arms must be 31 

7/64

”. If the bowl on the bowl trolley 

does not fit exactly in the bowl arms at this dimension, adjust slightly on the front legs of the mixer

.

Especially for table model - fixing and adjustment:

Kodiak 20 table model must be fixed to the table it is placed on.

Kodiak 20 table model is fixed with bolts in the two hind legs

.

Bolts with dimensions M10 x 20 mm + table top thickness and a 

washer are used.

The table must be suitable for machine’s weight and operation.

Height adjustment:

If the table is not fully even, justifications can be made by adjusting 

the two front legs.

The adjustment is made as described for the floor model - see above.

To raise leg 

turn 

clockwise

To lower leg  

turn 

anticlockwise

Together with the mixer comes a 32 mm 

fixed spanner to be used for adjustments.