10
Repair and maintenance
Only to be carried out by qualified and trained staff.
The lid of the mixer may only be removed when the cable to the mains supply has been removed.
Lubrication
Lubrication is only needed during repair
Mixer head: gear wheel, needle bearings and internal gear lubricated with
Molykote G-1502 FM
.
Attachment drive ( if supplied): gear wheel lubricated with
Renolit GreaseWay LiCa 80
.
Do not use any other grease types than specified.
The moving parts that belong to the bowl’s lifting mechanism all run in maintenance-free bearings and should therefore not
be lubricated.
Cleaning:
The machine may only be cleaned by trained staff and must be over 14 years of age.
Before any cleaning unplug the machine to prevent electrical hazards and accidental start of the machine.
The machine should be cleaned daily after use.
Remove tools, bowl and front and rear guards.
It should be wiped with a soft brush and clean water. Sulphonated soaps should be used with care, as they de-
stroy the lubricants in the machine.
The machine should never be rinsed with a hose.
Bowl, tools and guards are dishwasher-safe.
Plastic safety guard may be damaged if exposed to high temperatures for a prolonged period.
(General maximum temperature 60ºC, flush maximum 90°C, for maximum 30 seconds).
