12
Procedure in case of overloading:
Check error code below and follow the suggestion for solu-
tion.
When done, remove the error code by pressing
.
The machine can now be restarted by pressing
.
Overloading:
Always avoid overloading the machine.
Overloading will cause the frequency converter to stop the
machine.
,
or
will be displayed in the timer field.
Error codes and possible solutions:
For some errors, the control system will show an error code in the display:
User pressed
without raising the bowl to working height.
Solution:
Raise bowl to working height.
User pressed
without fitting the safety guard.
Solution:
Fit the safety guard.
The Thermal sensor in the motor has overheated.
Solution:
The error will disappear when the temperature has dropped to an acceptable level.
Stop the mixer and reduce the quantity of ingredients in the bowl. When it starts again, select a lower speed
.
There is an error in communication between the control panel and the frequency converter.
Solution:
Call the engineer.
Error in frequency converter.
Solution:
Call the engineer.
Thermal sensor in the frequency converter has cut out.
Solution:
The error will disappear when the temperature has dropped to an acceptable level.
Intermittent low voltage in the power supply.
Solution:
The power supply to the mixer should be checked by an expert.
Intermittent high voltage in the power supply.
Solution:
The power supply to the mixer should be checked by an expert.
The mixer is overloaded - continuously for 50 seconds
Solution:
Reduce the quantity in the bowl; alternatively, the product may need to be divided into smaller parts or diluted
before the machine is restarted. When restarted, select a lower speed, if speed was the problem
The error code is removed by pressing
The mixer is overloaded
- momentarily (overloaded 8 times within 20 seconds
Solution:
Reduce the quantity in the bowl; alternatively, the product may need to be divided into smaller parts or diluted
before the machine is restarted. When restarted, select a lower speed, if speed was the problem.
The error code is removed by pressing
Blockage.
Solution:
Remove the object that caused the blockage.
The error code is removed by pressing
,
and
can also occur when using the attachment drive.
