13
Reading the machines data:
Press the stop button for 5 sec. The machine’s data will then be displayed as alternating text in the display. There
are five readings corresponding to the five data sets described below:
• Data set 1:
States firmware version, displayed as “F” followed by three figures, e.g.
= firmware version 3.
• Data set 2
: States the machine’s running time, displayed as “t” followed by three figures, which indicate the number of
9.999-minute cycles, e.g.
= 2 x 9.999 min., or 19.998 min.
• Data set 3
: Displays four figures, which indicate the number of minutes the current cycle has been running, e.g.
= 1.234 min.I.e., if
is displayed followed by
, the machine has been running for 19.998
min. + 1.234 min., or a total running time of 21.232 min.
• Data set 4
: States the number of times the machine has been disconnected from the power supply (plug pulled out of
the machine/powercut/switched off) and restarted, displayed as “r” followed by three figures, which indicate the num
-
ber of restarts, e.g.
= 2 x 9,999 restarts, or 19,998 restarts.
• Data set 5
: Displays four figures, which indicate the number of restarts which have happened in the current cycle,
e.g.
= 1234 times. In other words, if
is displayed followed by
, the machine has restarted a
total of 19,998 + 1,234 times, or 21,232 times.
Reading the error log:
It is possible to display a log of the errors that have occurred:
• Hit emergency stop and press
next to
.
•
The display shows the latest error first.
• To scroll back through the errors, press
next to
; to scroll forward, press
next to
.
• The last eight errors can be displayed.
• Deactivate emergency stop to cancel the display
