Maintenance
42
322891 / 396630
V_01/02/2011
GB
1. Plug in the mains plug.
2. Turn pump on at the On-Off switch.
3. Open pressure line (turn on water spigot or nozzle).
4. Check to be sure that water is coming out.
If the motor does not start up or the pump does not build up any pressure or if similar faults occur,
turn the device off and try to remedy the error (
Faults and remedial measures – p. 43
Maintenance
Cleaning the filter
Depending on the contamination of the conveyed water, the filter must be cleaned regularly.
– Unscrew filter housing (6) and take out filter cartridge.
– If needed, soak filter cartridge in warm water for a short while.
– Rinse filter cartridge with clear water; brush out stubborn dirt
from inside using a soft brush.
Attention!
Danger of damage to the device!
The pump must not be allowed to run dry. Sufficient conveying medium (water) must
be on hand at all times.
Attention!
Danger of damage to the device!
Do not allow the pump to run longer than 10 min. when the pressure line is closed.
Allowing it to run longer can result in overheating and damage.
Danger!
Mortal danger due to electric shock!
Disconnect the mains plug before carrying out any work on the device.
Danger!
Risk of injury!
Make sure that the device and connected accessories are depressurized before car-
rying out any work on the device.
Attention!
Risk of damage to the device!
All gaskets must be renewed after each disassembly of components.
Attention!
Danger of damage to the device!
If the conveyed water is highly contaminated, clean the filter after each use. A
stopped-up filter will damage the pump!
Attention!
Danger of damage to the device!
Before installing the cleaned filter cartridge, check to be sure that there are no foreign
particles inside!
Intake of particles will damage the pump!
6
Gartenpumpe_322891_396630.book Seite 42 Montag, 7. Februar 2011 8:50 08
