How to set camera parameter and brightness:
Switch the welding vision system on. After the self test a video picture should appear on the
videomonitor.
Set your field of view with TELE and WIDE. Adjust focus with NEAR and FAR. Set brightness
by pressing DARK and BRIGHT
Save this information by pressing SET and 1 simultaneous.
Now press DARK until picture is much darker
Repeat saving by pressing SET and 2.
After starting the welding process, the close contact from the welding machine switches
internal from file 1 to file 2 and parameters from file 2 are used. The fine regulation for the
brightness can now done with the DIM potentiometer.
If picture is still to bright press DARK again until brightness is acceptable.
Repeat saving by pressing SET and 2.
After finishing the welding (i.e. If the contact on ext. Control is open) an automatic change
back to file 1 happens. Potentiometer DIM is now without function.
Please note:
DIM-Function is only active if the contact on ext. control is closed
Variovision, Pöttinger Straße 23, DE-82041 Oberhaching, www.variovision.tv, info@variovision.tv
12/14
WVS-16
