POWXG6460
EN
Copyright © 2014 VARO
P a g e
|
9
www.varo.com
7.1
Collect box locking handle
Your shredder is equipped with a safety switch,
it does not work when this switch is not pushed
by the collect box locking handle.
After sliding in the collect box you have to
move the ‘collect box locking handle’ upwards,
to close the safety switch. Then only you can
start the shredder.
To Remove collect box : before you can
remove it, you have to pull t
he ‘collect box
locking handle’’ down. When collect box is not
in its place, the shredder can not not be
operated. NOTE ! After re-placing the collect
box, you always have to push the ON switch to
make shredder work again.
8 OPERATION
8.1
Putting into operation
Before you plug the connection cable of the mains
supply into the socket, you have to retract the grey
"pull-out" protection, plug in the socket and then let
spring back the protection. Otherwise caused by
vibrations the plug will be disconnected from the
socket.
8.2
On/off switch
Press the green button to switch on the shredder.
Inrush currents can cause short-time voltage drops; under unfavourable power supply
conditions, other equipment may be affected (if the system impedance of the power supply is
lower than 0,127 + j0,079 Ohm, disturbances are unlikely to occur); if you need further
clarification, you may contact your local power supplier.
Press the red button to switch it off.
Note: This machine is equipped with an electromagnetic switch to prevent it
from being unexpectedly switched on when power source recovered.
