POWDP4060
EN
Copyright © 2019 VARO
P a g e
|
10
www.varo.com
9.6.4
Scraping
For scraping, select a high oscillation rate.
Work on a soft surface (e.g. wood) at a flat angle and apply only light pressure. Otherwise the
scraper can cut into the surface.
10 CLEANING AND MAINTENANCE
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Make sure no water can reach the inside of the power tool!
11 TECHNICAL DETAILS
Model nr.
POWDP4060
Voltage
20 V
Number of speed settings
6
No load speed
5000-20000 /min-1
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
82 dB(A)
Acoustic power level LwA
93 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
8,7 m/s²
K = 1,5 m/s²
