POWAIR0806
EN
Copyright © 2014 VARO
P a g e
|
6
www.varo.com
and cylinder cap.
Worn or damaged O-rings or
seals.
Check and replace O-rings
or bumper.
Blade driving fastener
too deep.
Worn bumper.
Replace bumper.
Air pressure is too high.
Adjust the air pressure.
Tool does not operate
well: can not drive
fastener or operate
sluggishly.
Inadequate air supply.
Verify adequate air supply.
Inadequate lubrication.
Place 2 or 6 drops of oil into
air inlet.
Worn or damaged O-rings or
seals.
Check and replace O-rings
or seal.
Exhaust port in cylinder head
is blocked.
Replace damaged internal
parts.
Tool skips fasteners.
Worn bumper or damaged
spring.
Replace bumper or pusher
spring.
Dirt in front plate.
Clean drive channel on front
plate.
Dirt or damage prevents
fasteners from moving freely
in magazine.
Magazine needs to be
cleaned.
Worn or dry O-ring on piston
or lack of Lubrication.
O-ring needs to be replaced
and lubricate.
Cylinder covers seal leaking.
Replace Sealing washer.
Tool jams.
Incorrect or damaged
fasteners.
Change and use correct
fastener.
Damaged or worn driver
guide.
Check and replace the
driver.
Magazine or nose screw
loose.
Tighten the magazine.
Magazine is dirty.
Clean the magazine.
12
ENVIRONMENT
Should your appliance need replacement after extended use, do not discard it with the
household rubbish but dispose of it in an environmentally safe way.
