POW6128
EN
Copyright © 2014 VARO
P a g e
|
10
www.varo.com
NOTE: When shaping it is advisable to achieve a trapezoidal shape (Fig. 11).
This is where the bottom is wider than the top. A trapezoidal cut corresponds
to the natural growth of plants and results in optimal hedge growth, as it will
expose more light to the bottom of the hedge.
9 AFTER USE
Switch the product off, allow the engine to cool down and then remove the spark plug
connector.
Check, clean and store the product as described below.
9.1
The golden rules for care
WARNING! Always switch the product off, let the product cool down and
disconnect the spark plug connector before performing inspection,
maintenance and cleaning work!
Keep the product clean and free from debris after each use and before storage.
Regular and correct cleaning of this product will help ensure safe use and prolong the life
of the product.
Inspect the product before each use for worn and damaged parts. Do not operate it if any
parts are broken or show signs of wear.
Ensure the air vents remain clear from obstruction at all times.
WARNING! Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified specialist!
9.2
General cleaning
Clean the product with a dry cloth; use a soft brush for hard to reach areas.
Pay particular attention to the air vents (5) and to the cutting blade.
Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be harmful to
its surfaces.
9.2.1
Care and maintenance
Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorized service center before using the product again.
9.2.2
Cutting blade
WARNING! Wear safety gloves when working on the cutting blade and close
to it! Use appropriate tools to remove debris e.g. a brush or wooden stick!
Never use your bare hands!
Keep the cutting blade (1) clean and free of debris. Remove trimmings.
Keep the cutting blade (1) sharp to retain a good cutting performance. Replace a worn or
damaged cutting blade with a new one of the same type.
