POW64122
EN
Copyright © 2013 VARO
P a g e
|
16
www.varo.com
users of the chain saw, we recommend to have the chain sharpened by a specialist in any
authorized service.
Warning: when having wrong sharpened chain, there may occur a higher
danger of kickback.
To sharpen the saw chain, use the suitable sharpening tools:
round chain file
file leading
chain measuring caliber.
These tools can be bought in any specialized stores.
To gain well shaped sawdust particles, use sharp chain. If there appears wooden powder,
you must sharpen the saw chain.
Warning: all cutting teeth must be similarly long. Different length of the
teeth can cause rough run of the chain or its rupture, as well.
Minimum length of the teeth must be 4mm. If they are shorter, remove the saw chain.
Angles, which the teeth are under, must be followed.
To sharpen the chain basically, make 2 to 3 pulls of the file from the inside out.
Warning: after 3 to 4 of your sharpening of the cutting teeth, have the saw
chain sharpened in any authorized service. They will sharpen the depth
limiter as well, which provides the distance.
Chain sharpening
The pitch of the chain (fig. 20) depends on the model.
POW64122
Pitch
9.525
mm (3/8”)
Gauge
1.27 mm (0.05
”)
Sharpen the chain using protective gloves and a round file of ø5/32” (4mm).
Always sharpen the cutters only with outward strokes (fig.21) observing the values given in fig.
20. After sharpening, the cutting links must all have the same width and length.
Warning: a sharp chain produces well-defined chips. When your chain
starts to produce sawdust, it is time to sharpen.
After every 3-4 times the cutters have been sharpened you need to check the height of the
depth gauges and, if necessary, lower them using the flat file and template supplied optional,
then round off the front corner. (Fig. 22)
WARNING: Proper adjustment of the depth gauge is as important as proper
sharpening of the chain.
11.4
Guide bar
The bar should be reversed every 8 working hours to ensure uniform wear. Keep the bar
groove and lubrication hole clean using a bar groove cleaner (optional). (fig. 23) check the bar
rails frequently for wear and, if necessary,
Warning: never mount a new chain on a worn sprocket or self-aligning ring.
