POWXG6026
EN
Copyright © 2014 VARO
P a g e
|
10
www.varo.com
11.2
Changing /draining the oil.
The oil drain plug is located under the dipstick, at the base of the engine.
Have a container ready to catch the oil.
Remove the drain plug.
Once the oil has been emptied, replace the drain plug.
Make sure that the washer is in place !
To fill proceed as described under 11.1 oil (fill/check).
Start the engine and allow it to run briefly. Stop the engine, wait one minute and check the oil
level. Top up if necessary.
11.3
Draining the fuel tank / carburettor
Place an approved gasoline container below the carburettor, and use a funnel to avoid
spilling fuel.
Remove the drain bolt, then move the fuel valve lever to the ON position.
After all the fuel has drained into the container, reinstall the drain bolt and washer.
Tighten the drain bolt securely.
11.4
Replacing and cleaning the spark plug
(Only use F6RTC (Nanjing Huade NHSPLD) with engine DY1P64F)
After the engine has cooled down, remove the spark plug with the provided socket
wrench.
Clean the spark plug with a wire brush.
Use a setting gauge (adjustment gauge), and adjust the electrode gap to 0.75 mm.
Insert the spark plug carefully by hand, in order to avoid any wrong installation (not
properly aligned to thread).
After the spark plug has been tightened manually, use a wrench to tighten the spark plug
tightly to its washer.
11.5
Lubrication instructions
Caution: disconnect spark plug before servicing.
WHEELS-Lubricate the ball bearings in each wheel at least once a season with a light oil.
BLADE CONTROL - Lubricate the pivot points on the start/stop handle of the engine and
the brake cable at least once per season with a light oil. The start/stop handle of the
engine must freely move in both directions.
