POWXG6490
EN
Copyright © 2014 VARO NV
P a g e
|
8
www.varo.com
NOTE: The metal parts surrounding the motor are not hot during operation.
After several hours of operation however, the pump can become quite hot.
This does not harm the machine, and you can proceed with your work once
the pump has cooled. When you are working with large logs or very hard
wood, it is important that the oil in the pump does not overheat.
8
MAINTENANCE
We recommend to perform maintenance work with great care so that the tool’s properties in
relation to performance, stability and lifetime do not deteriorate.
The tool must always be disconnected from the power source when undergoing maintenance
(pull the plug from the socket).
Maintenance that is not explicitly described in this instruction manual must only be performed
by professionals, as dangerous circumstances for which the user is not prepared may arise.
Special maintenance or replacement of parts must only be performed by professionals.
The manufacturer shall not be liable for material damage or injury to persons or animals in the
event these instructions are not observed.
8.1
Changing the Hydraulic Oil
After 400 operating hours, the oil must be replaced. (see recommended oil type point 3)
Perform as following :
Make sure that the machine’s push plate is fully retracted.
Remove the screw cap (fig A).
Place a tub or bucket that can hold approx. 4 l. of oil under the log splitter. Tip the log
splitter to allow the oil to drain (fig B).
Tip the log splitter in the opposite direction (fig C), and pour 2.4 l. of oil into the hole.
Using the cleaned oil dipstick, check to make sure that the oil level is between the two
markings on the dipstick.
Clean the cap and screw and carefully re-place them again.
CAUTION: Dispose of used oil in the manner prescribed by relevant
regulations!
Warning: never mix different oils! Return used oil to the vendor or dispose
of it at a municipal waste disposal facility.
8.2
Oil Refills
Check the oil level regularly. It should be between the two marks on the dipstick. When
needed, add oil.
8.3
Recommended oils
For the hydraulic system, we recommend the following oils:
OKQ8 Hydraulic Oil LT or Shell Tellus T22 or BP Energol HCP22 or Mobil DTE11 or equiv.
Do not use other oils.
8.4
Sharpening the Cleaving Wedge
After longer use or as needed, you should sharpen the cleaving wedge with a fine-grained file.
Make sure you file all edges and irregularities.
