POWXG8020LI
EN
Copyright © 2014 VARO
P a g e
|
6
www.varo.com
Do not attempt to remove cut material or hold material to be cut when blades are moving.
Make sure trimmer switch is off when clearing jammed material from blades. Do not grasp
the exposed cutting blades or cutting edges when picking up or holding the hedge
trimmer.
CAUTION: Blades coast after turn off.
Don’t force hedge trimmer, it will do the job better and with less likelihood of risk of injury
at the rate for which it was designed.
Stay alert, watch what you are doing. Use common sense. Do not operate hedge trimmer
when you are tired.
Maintain hedge trimmer with care, keep cutting blades sharp and clean for best
performance and to reduce the risk of injury.. Keep handles dry, clean and free from oil
and grease.
Always fit the blade guard onto the cutting bar if you wish to transport or store your hedge
trimmer
7 BEFORE USING THE TOOL FOR THE FIRST TIME
7.1
Advantage of Li-ion batteries.
40% More Performance
40% Less Weight
100% Longer Life
40% More Compact
No Memory Effect
Environment-Friendly
7.2
Charging Procedure
The charging procedure starts as soon as the mains plug of the charger is plugged into a
power socket and the battery (14) is inserted into the charging compartment (13).
Thanks to the intelligent charging PCB (Protective circuit board), the charging condition of the
battery is automatically detected and the battery is charged in optimum condition.
(PCB takes into account : Over Charging/Discharging, Voltage and Current, Battery
temperature, Short-Circuit, Overload, Each Cell Unbalance (Out-put, In-put), resulting in
continuous optimum Voltage & Current when Charging or Working.
This gives longer life to the battery and always leaves it fully charged when kept in the charger
for storage.
Charge battery pack only with the charger provided.
Please note :
With continuous or several repetitive charging cycles without interruption, the charger can
warm up. This is not harmful and does not indicate a technical defect of the unit.
A battery that is new or has not been used for a longer period does not develop its full
capacity until after approximately 5 charging/discharging cycles. Leave such batteries in
the charging compartment until they have clearly warmed up.
A significantly reduced working period after charging indicates that the batteries are worn
out and must be replaced.
