POW4110
EN
Copyright © 2014 VARO NV
P a g e
|
6
www.varo.com
7.7
Operating instructions
Make sure that the machine has reached its full speed before placing the machine on the work
piece. This will prevent an overload of the machine. For sanding wood, place the machine
approximately 15° out of the grains of the wood. Move the belt sander continuous over the
work piece.
8 TROUBLESHOOTING
In case the belt sander does not work well, we give you some possible causes and solutions.
Problem
Cause
remedy
The electromotor gets
hot
The cool ventilation slots in the
motor are stopped up with dirt
Clean the cool ventilation
slots
The connected machine
does not work
Interruption in the mains
connection
Check mains connection
for fracture
The dust is not
absorbed
This can be caused by a
stopped up dust extraction
Clean your dust collection
opening
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
9.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Voltage / frequency
230V / 50Hz
Power input
800 W
No load sander paper speed
0-300 m/min
Sanding belt size
76 x 457 mm
Insulation class (Double insulated)
II
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
93 dB(A)
Acoustic power level LwA
104 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
Max 3.2 m/s²
K = 1,5 m/s²
