POWC40100
EN
Copyright © 2021 VARO
P a g e
|
5
www.varo.com
▪
Take special care when sanding lead based paint:
−
All persons entering the work area must wear a mask specially designed for protection
against lead paint dust and fumes.
−
Children and pregnant women must not enter the work area.
−
Do not eat, drink or smoke in the work area.
▪
Do not leave the tool running. Operate the tool only when hand-held.
▪
Ventilate your work area adequately when you perform sanding operations.
▪
Be sure that there are no cracks or breakage on the pad before use. Cracks or breakage
may cause a personal injury.
7 OPERATION
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ..).
7.1
Switching on/off
Connect the plug to the power supply.
▪
Switch the power tool on: push the ON/OFF switch button (1
) forwards onto the “
I
”
position.
▪
Switch the power tool off: pull the ON/OFF switch button backwards to the “
O
” position.
WARNING: Never use the machine for sanding magnesium work piece.
7.2
Attaching the sandpaper
▪
Open the paper clamps.
▪
Take sanding paper of the required grain size and place it on the sanding pad.
▪
Make sure that the perforation in the paper corresponds with those on the sanding pad.
▪
Fold tha sanding paper at both ends around the edges of the sanding pad.
▪
Close the paper clamps one by one.
▪
Make sure that the ends of the sanding paper are clamped.
▪
The sanding paper must be fitted firmly on the sanding pad and should not come loose.
7.3
Collecting the dust
▪
For a better dust extraction of the working surface, your sanding machine can be
connected to the ordinary vacuum cleaner for house-use.
▪
Slide the suction mouth of a vacuum cleaner onto the connection.
▪
The vacuum-cleaner connecting piece is supplied with the appliance.
8 TECHNICAL DATA
Power rating
150W
Mains voltage
220-240V
Frequency
50Hz
Sanding surface
90 X 186 mm
No load speed
12000 min
-1
