POWX00405
EN
Copyright © 2019 VARO
P a g e
|
6
www.varo.com
7.4
Changing the angle of the tool
The tool’s angle can be changed by pressing/pushing the release button and turn the handle
clockwise or counter-clockwise.
To change the tool’s angle, stop the machine and using the button.
Do not change the angle of the tool, when it is operating!
7.5
Working spot light
Pushing the operating button will turn on the working spot light.
Leaving the operating button will switch off the working spot light.
7.6
Screw insertion
Set the direction of rotation of the screwdriver to the clockwise direction. Insert the screw-bit
into the slot in the head of the screw. Hold the screw bit perpendicular to the head of the
screw, otherwise the screw or the screw head may be damaged. Press the screw bit against
the screw with a constant pressure while driving in the screw.
When the screw is completely screwed in, hold the machine firmly and
release the On/Off trigger, otherwise the screw or the screw head may be
damaged. If the On/Off trigger is not released immediately a high torque
could also damage the screw-bit or the screwdriver.
7.7
Screw removal
Set the direction of rotation of the screwdriver to the anticlockwise direction. Insert the screw-
bit into the slot in the head of the screw. Hold the screw-bit perpendicular to the head of the
screw, otherwise the screw or the screw head may be damaged. Press the screw bit against
the screw with a constant pressure while removing the screw.
8 CLEANING AND MAINTENANCE
8.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
8.2
Maintenance
Attention! Always switch off the screwdriver and lock the switch in the OFF position before
carrying out any work on the machine.
