POWX0047LI
EN
Copyright © 2015 VARO
P a g e
|
7
www.varo.com
7.5
Forward/reverse selector (right/left rotation selector) (4)
The drill has a forward/reverse selector located above the switch trigger.
F(Forward) (Forward): Press selector on right side of machine (to the left side): drill turns
right (forward, fasten screws)
R(Reverse) (Reverse): Press selector on left side of machine (to the right side): drill turns
left (reverse/ loosen screws)
CAUTION: To prevent damage to the gearbox, always allow the chuck to
come to a complete stop before changing the direction of rotation or
selecting another speed (HI-LO). To stop, release the trigger switch.
7.6
Speed selector (3)
Your cordless drill has a two-speed gear, designed for drilling or driving at LO or HI speed. A
slide switch is located on top of your drill to select either LO (1) or HI (2) speed.
7.7
LED worklight (6)
Your cordless drill is equipped with an LED light at the front (above the ON/OFF switch) above
the battery pack. The white LED light will light when you operate the machine, providing the
work area to be lighted.
7.8
TPR soft grip
Your cordless drill is equipped with TPR soft grip and protective parts. TPR
(Thermoplastic rubber) is elastic, chock absorbing and environmental friendly (recyclable).
8
(PRE)OPERATION
8.1
Battery charging
Use only the battery charger supplied with your tool. Only these battery chargers are matched
to the lithium ion battery of your power tool.
Note: The battery is supplied partially charged. To ensure full capacity of
the battery, completely charge the battery in the battery charger before
using your power tool for the first time. The lithium ion battery can be
charged at any time without reducing its service life. Interrupting the
charging procedure does not damage the battery.
8.2
To install or remove the battery pack
8.2.1
To remove the battery
Depress both the battery release buttons and gently pull the battery out of the drill.
8.2.2
To install the battery
Hold the drill upright in one hand and the battery in your other hand. While pressing with two
fingers on the battery release buttons, insert the battery until it clicks into place. Do not use
excessive force when inserting the battery. If the battery does not slide in easily, it is not being
inserted correctly. It is also possible that there could be damage to the battery, battery
terminals or the drill.
