POWX04761
EN
Copyright © 2019 VARO
P a g e
|
6
www.varo.com
▪
There are certain applications for which this tool was designed. The manufacturer strongly
recommends that this tool cannot be modified and/or used for any application other than
for which it was designed.
▪
Use the machine with both hands at all times. Loss of control can cause personal injury.
▪
Keep power supply cord clear from the working range of the machine. Always lead the
cable away behind you.
▪
Immediately switch off the machine if unusual vibrations or if other malfunctions occur.
Check the machine in order to find out the cause.
▪
The dust that arises when working with this tool can be harmful to health. Use a dust
absorption system and wear a suitable dust protection mask and remove deposited dust
with a vacuum cleaner.
▪
Do not work with materials containing asbestos (asbestos is considered carcinogenic).
▪
Dust from material such as paint containing lead, some wood species, minerals and metal
may be harmful (contact with or inhalation of the dust may cause allergic reactions and/or
respiratory diseases to the operator or bystanders); wear a dust mask and work with a
dust extraction device when connectable.
▪
Certain kinds of dust are classified as carcinogenic (such as oak and beech dust).
especially in conjunction with additives for wood conditioning; wear a dust mask and work
with a dust extraction device when connectable.
▪
Follow the dust-related national requirements for the materials you want to work with.
6.1
Electrical connection
The network voltage must conform to the voltage indicated on the tool name plate. Under no
circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Centre. Do not try to
repair the damaged cable yourself. The use of damaged power cables can lead to an electric
shock.
7 ASSEMBLY
7.1
Attaching and changing sanding disc (Fig. 3)
▪
Insert the hex wrench (size 5) into the hexagonal screw bolt on the sanding block.
▪
Hold the sanding pad firmly, and then turn the wrench counter clockwise to dismount the
pad.
▪
Place the sanding disc in the centre of the sanding pad and press on the holes in the
sanding disc must be in alignment with the extraction holes in the sanding pad.
▪
For round sanding pad only: conduct a test run to check that the sanding disc is clamped
in the centre.
Warning: Only install the specified sanding pad on the machine. In order to
ensure optimal performance, the machine should be run at slightly lower
speed for several minutes to make the grinding pad fit the sealing surface
perfectly. During this process, the white foam particles will come out from
the sanding head. However, this won't damage the machine.
7.2
Extension shaft (Fig. 4)
▪
Use the extension shaft (O) according to the intended operation for higher work surface
▪
Loosen the sleeve on the dust extraction outlet (N) of the upper shaft (J).do not remove
the sleeve from the outlet.
▪
Align the rear handle (O
1
) with the main handle and insert the sleeve (O
3
) on the extension
shaft (O) into the outlet (N) with a twist motion all the way to the stop.
▪
Adjust the length of the extension shaft (O) if necessary.pay attention to the
marking “max
1.65
m” on the extension shaft.tighten the sleeve (N) after assembling/adjusting the
extension shaft.
