POWX139
EN
Copyright © 2014 VARO
P a g e
|
10
www.varo.com
9 CLEANING AND MAINTENANCE
Always ensure that the tool is switched off and the plug is removed from the power
socket before making any adjustments or maintenance procedures.
Keep the tool
’s air vents unclogged and clean at all times.
9.1
Replacing the carbon brush
During use, the carbon brushes will
wear down. This will result in a
possible loss of power and excessive
sparking seen through the ventilation
slots. When the carbon brushes have
worn down to approximately 4-5 mm,
they will require replacing. Carbon
brushes must always be replaced in
pairs.
Tool service and maintain must be
performed only by qualified repair
personnel.
10 TECHNICAL DETAILS
Model nr.
POWX139
Rated Voltage
230-240 V
Rated Frequency
50 Hz
Rated Power
400 W
Variable speed
300-1700 min-1
Working bar length
83 mm
Sanding belt size
13x457 mm
Cable length
3 m
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
80 dB(A)
Acoustic power level LwA
91 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
1,2 m/s²
K = 1,5 m/s²
