POWX1705
EN
Copyright © 2017 VARO
P a g e
|
6
www.varo.com
6 CONNECTING ACCESSORIES TO THE COMPRESSOR
Before connecting accessories, always make sure that the compressor is
OFF.
All the accessories are connected to the compressor using the rubber hose (3) fitted with fast
connects.
Connect the accessory required to end (B) of the rubber hose (fig. 1) pushing fitting A of
the accessory firmly inside B. A click indicates that the accessory is connected.
When you have finished using the compressor, disconnect the rubber hose from the
accessory (fig. 2) pulling back the ring-nut of connector B.
7 USE OF THE COMPRESSOR
Connect the accessory required. Connect the compressor to the mains using the power
cord 4 located in housing 14 on the front of the compressor.
Press switch 1 to start the compressor.
When you have finished using the compressor, press switch 1 and disconnect the power
cord 4 from the current outlet, replacing it in housing 14 on the front. Run the accessory
connected dry until there is no more compressed air in the hose.
It is good practice to stow all the accessories in housing 14 on the front of the compressor.
Always wait at least 10 seconds from when the compressor has been switched off before
restarting this.
This compressor is suitable for minor blowing and dust removal jobs. It is
NOT suitable for prolonged use, for treating large surfaces and for
removing dust from badly-caked areas.
The compressor must be used in the horizontal position only, resting on its
rubber feet.
7.1
Maintenance
Never clean the machine and its components with solvents, flammable or toxic liquids. Us only
a damp cloth making sure you have unplugged the compressor from the current outlet.
The compressor must be disposed in conformity with the methods provided
for by local regulations.
8 INFLATION GUN
For inflating tires, rubber dinghies, air beds, footballs and other objects
PRESSUE LEVEL: 1-4 bar
Warning: Do not direct the jet of compressed air towards people or animals.
Never inflate the objects above the recommended inflation pressure as this
may be dangerous and cause damage and/or injuries.
For this operation, use of the approved inflation gun that can be purchased
separately is recommended.
