POWX230
EN
Copyright © 2021 VARO
P a g e
|
6
www.varo.com
It can only protect you when the power mains to which the tool is plugged is properly
grounded.
Have the proper outlet installed by a qualified electrician.
Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the tool is properly grounded.
6.2
Diamond blades
Only use 180mm diameter Continuous Rim Wet Diamond blades.
DO NOT use larger, segmented or 'turbo' blades, wood sawing blades, or any other
cutting device. : Severe bodily injury, and damage to your saw can occur !
Inspect blades daily for cracks or uneven wear. Discard cracked, chipped or bent blades!
Ensure the blade is mounted with the rotation arrow in the proper direction and is securely
tightened with a wrench.
Always ensure a continuous flow of water on both sides of the blade before cutting any
material.
Do not operate the machine without all safety guards in position
Do not force the material into the blade. Let the blade cut at its own speed.
7 ASSEMBLY
ATTENTION ! Disconnect the power plug before carrying out any
adjustments or maintenance.
7.1
Mounting of disc (fig 1a, 1b &1 c)
7.2
Assembly of dividing knife and protective guard (fig 2)
A
– Safety guard
B
– Dividing knife
7.3
Mounting of guard / angle guard. (fig 3)
7.4
Inserting the water reservoir (fig 4)
8 OPERATION
The base of your Tile cutter must be well positioned and firmly installed on a flat and solid
surface in an area inaccessible to children.
It must be screwed on a stable base (bench, universal base).
Insure of a strong tightening of the diamond disc between the flanges before starting.
8.1
Switching on and off
To turn the machine ON, press the green push button.
To turn the machine OFF, press the red push button.
8.2
Angle adjustment of the table (fig 5)
Allows to cut a tile at 45°.
Loosen the table locking screws on the front and back of the table.
incline the table to the desired angle and re-tighten.
8.3
Water reservoir
When cutting with this tool, the disc should always be in contact with water.
When storing, remove the reservoir and clean it from sediments of cutting.
