POWXG6211TA
EN
Copyright © 2019 VARO
P a g e
|
10
www.varo.com
▪
Move from position 1 to position 2
▪
Turn right and proceed towards position 3
▪
Turn left and move towards position 4
▪
Repeat the above procedures as required.
8.7
Blade (Fig. 6)
Always unplug the lawn mower before checking the blade in any way. After you have stopped
the motor, remember that the blade will still keep running for a few seconds before it comes to
a standstill. Never attempt to stop the blade. Check at regular intervals if the blade is properly
fastened, in good repair, and whether it is well sharpened. Regrind or replace it, if necessary.
If the rotating blade hits any object stop the lawn mower and wait until the blade has
completely come to a standstill. Then check the condition of the blade and the blade holder.
Immediately replace the blade if it has got damaged.
To avoid possible damage to you, please make sure to follow the below
instructions during operation:
Never use the machine without rear deflector (7) or grass box (2) connected.
Do not attempt to lift up the rear part of the machine, instead, to hold up the
front part of machine to get the machine re-start when it fails to rotate owing
to too strong grass.
On slopes, always mow sideways, never up and down. Avoid extremely steep
slopes.
Never put your hands or feet near or under rotating parts. Always keep away
from the discharge opening, if possible.
If the blade is slipping, then tighten the bolt holding the blade with a wrench. See fig.6.
Warning! Observe the following precautions:
▪
Disconnect the mower from the mains and wait until the blade has stopped rotating before
proceeding.
▪
Be careful not to cut yourself. Use heavy-duty gloves or a cloth to grip the blade.
▪
Only use the specified replacement blade.
▪
Do not remove the impeller for any reason.
See paragraph “Replacing the blade”
8.8
Different uses
WARNING: only switch to different use with a stopped motor and standstill
blade.
You can mowe with or without the grass box installed.
