19.0 Panel Mount PC
486-0010-01-02
6
Panel Mount Procedure
Panel Mounting Procedure:
1- Cut and drill the panel (refer to the panel mount drawing, Figure A). Measurements are
provided in inches and millimeters.
Panel Mounting Cutout:
1- If access to the bottom of the enclosure is not available following installation, attach the
power and all necessary cables to the bottom side of the enclosure at this time.
2- Install the enclosure in the prepared cutout.
3- Secure the enclosure using the lock nuts and washers, supplied with the unit, behind the
holes running along the sides and the top and bottom of the cutout in the panel. Extra lock
nuts and washers are provided.
NOTE:
Use #10-32 nuts for mounting.
4- Tighten all mounting hardware to a torque of 24 inch-pounds.
ATTENTION:
Mounting nuts must be tightened to a torque of 24 inch-pounds to provide a
proper panel seal and avoid potential damage. Vartech Systems assumes no responsibility for
water or chemical damage to the monitor or other equipment within the enclosure due to
improper installation.
5- Attach the power, video and system cables to the bottom side of the enclosure if you have
not already done so.
Panel Mount Drawing: Detail –A–
