Varytec VF - 120, User Manual

5 / 9 

4.  Unpacking and Inspection 

ent damage caused by transportation. In the event that the unit’s housing or cable 

 damaged, do not plug it in and do not attempt to use it until after contacting your 

deale

5.  Setup 

packing materials from shipping box. Check that all foam and plastic 

padding is removed, especially

a flat surface and remove the liquid tank cap. 

mended high-quality water-based 

level or suspended overhead. Install the 

guarant

and top

 the public area. Please consider that liquid may 

acciden

ay from persons. The minium distance should be 

eed 15°. 

This device is constructed for a standing 

 device is to be installed 

The installation of the device has to be built and constructed in a way that it can hold 10 

times the w

This de

overhea

Open the shipping carton and verify that all equipment necessary to operate the system 

has arrived intact. Accompanying the S-120 foam machine should be a hanging bracket 

and fluid tank. If any equipment is missing contact your dealer immediately. 

Before beginning your initial setup on the Foam Machine, make sure that there is 

no evid

is

r for assistance. 

1.  Remove all 

 in the nozzle area. 

2.  Place the machine on 

3.  Fill with Varytec Foam Liquid or other dealer-recom

snow or foam fluid. Any other types of fluid can damage the unit. When filled, place 

cap back on liquid tank. 

6.  Installation 

The Foam Machine may be installed at floor 

Foam machine in a well-ventilated area. Never cover the unit’s vents. In order to 

ee adequate ventilation, allow a free air space of at least 20 cm around the sides 

 of the unit. Install the device out of

be spilt during operation around the device. The resulting slippery surface can cause

ts. Position output of foam aw

1.5  m. Only install the machine on scratch resistant and water resistant surfaces. 

Please make sure that the inclination angle does not exc

installation only. If the

overhead, the following safety instructions are binding: 

eight for 1 hour without any harming deformation. 

vice is constructed for a standing installation only. If the device is to be installed 

d, the following safety instructions are binding: