Performance Note
♦
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when installing
your unit.
♦
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
after being turned off.
♦
All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
Maintenance
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and
the fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it is
recommended to run a cleaning solution composed of 80% distilled water and 20% ACETIC ACID through the
system to prevent the accumulation of particulate matter in the heating element.
The recommended cleaning regimen is as follows:
1.
Empty all fog liquid from the machine. Add cleaning solution to tank. Plug unit in and begin warm up.
2.
Run the unit in a well-ventilated area until the tank is almost empty. Do not allow the pump to run dry.
3.
Cleaning is now complete. Refill with fog liquid. Run the machine briefly to clear any cleaning solution from
the pump and heater.
4.
Do not operate the fog machine without liquid at any time.
Note: All fog machines are prone to clogging due to the thick consistency of fog liquid and the high
temperature at which it vaporizes. However, a properly maintained fog machine should provide years of
reliable use.
Clean with a dry cloth only. Store dry.
Cleaning your fog machine regularly will help reduce costly replacement and repair charges.
Storage
1. When storing run distilled water (not tap water) through the system as described in the cleaning
regimen above. This will help avoid any particles condensing inside the pump or heater.
2. It is strongly recommended to test-run the machine on a monthly basis in order to achieve its best fogging
condition. A test-run consists of warming up the machine followed by a few minutes of emission. After that,
follow Step 1 under Storage.
Please read and save these instructions.
