SÉLECTEUR RF HR
L’unité de ventilation peut être étendue avec un sélecteur RF à capteur HR
(humidité) qui augmente provisoirement le débit de ventilation en cas de
hausse du taux d’humidité, par exemple lorsque vous prenez une douche
(= fonctionnement à la demande). Une pression répétée sur la zone de
commande inférieure vous permet de faire défiler les différentes positions.
La LED dans le coin supérieur droit indique la position.
Symbole Description
L’appareil tourne en position 1 (basse)
Vasco recommande d’utiliser cette position en cas d’absence.
L’appareil tourne en position 2 (moyenne)
Il s’agit de la position standard durant la présence.
L’appareil tourne en position 3 (haute)
Il s’agit de la position recommandée pendant la douche et le bain.
Elle peut également être utilisée en cas de besoin de ventilation accru
(visiteurs, fête de famille…).
L’appareil tourne en mode automatique moyen
Dans cette position, le débit d’air reste identique au débit de la dernière
position de ventilation sélectionnée. En cas d’augmentation brusque de
l’humidité relative (douche), l’unité de ventilation se met automatiquement
en position moyenne.
L’appareil tourne en mode automatique maximum
Dans cette position, le débit d’air reste identique au débit de la dernière
position de ventilation sélectionnée. En cas d’augmentation brusque de
l’humidité relative (douche), l’unité de ventilation se met automatiquement
en position haute.
Attention :
la gaine d’évacuation de l’unité de ventilation abrite un capteur HR
interne. Le capteur HR interne et l’éventuel sélecteur RF externe indiquent le
débit d’air recommandé en fonction du taux d’humidité. L’unité de ventilation
ajustera son débit de ventilation en fonction de la demande la plus élevée.
Le capteur HR interne réagit en fonction de la valeur HR de l’ensemble du
logement. Le sélecteur HR externe réagit seulement en fonction de la valeur HR
de la pièce où il est installé.
8 DISPOSITIFS DE COMMANDE