Personal aXsGUARD - 7.7.1
Chapter 4. Server-Side Configuration
© VASCO Data Security 2013
22
Parameter
Description
Destination IP
Specify the destination IP address or network for which SNAT must be
performed. Use the CIDR notation to specify a network, e.g. 192.168.0.1/24.
If left empty, the rule applies to any destination IP address.
Protocol
Select the appropriate protocol from the drop-down list (TCP, UDP or Any).
Port
The port of the destination device / network.
Coming from IP
The rule will be applied only to packets matching the specified source
address, e.g.
80.90.100.200
. If left empty, any source IP is assumed
and the rule applies to all packets.
Interface
LAN / WAN. The network device that handles the traffic to be SNATed or
Masqueraded.
Target
Select SNAT or Masquerade.
Source IP
The source IP in the packets will be replaced with the source IP specified
here.
Source Port
The source port in the packets will be replaced with the source port specified
here.
Table 4.8. PAX SNAT and Masquerading Settings
Control Buttons
• Add: Use this button to add a NAT rule, once your parameters - as explained in the table above - have
been entered.
• Clear: Use this button to clear the data that has been entered in the NAT rule fields.