Assembly
Tools Required:
Note: A 1/4” and 7/16” Flat Plate Wrench is supplied.
Or use
1/4” Nut Driver (recommended) or 1/4” Socket and Ratchet (6.5mm)
7/16” Wrench Open End (11mm), for belt aligner adjustment.
1A) Install knob and bolt through
pointer and spacer outside of
both side panels. Connect to
weldnut and hexnut on other
side as shown above.
Install (3) Sheet Metal Screws
(each corner)
Attach Front Panel to Left Side Panel
Attach Back Panel to Left Side Panel
Attach Front & Back Panel to Right Side Panel
Install (4) heater mounting
screws (2 each side)
Heater wires are towards back of chamber
Do not over tighten fasteners.
Chamber Assembly and Heater Installation
Front Panel
Back Panel
Side Panel
1B
2
3
4
5
6
See Pg. 5 for
heater assembly
Pointer Spacer
Knob Bolt
Weldnut Hexnut
1A
Pg. 8
Summary of Contents for D-100
Page 16: ......
