14
1
Hold the trigger in the full brake position while powering
on the transmitter. The LED flashes rapidly, indicating the
programming mode is active.
2 throttle end Point
Continue holding full throttle. Turn the
TH TRIM knob to adjust the full throttle end point.
3 Brake end Point
Hold the trigger in the full brake position.
Turn the TH TRIM knob to adjust the full brake end point.
Return the trigger to the center position.
4 left Steering end Point
Hold the steering wheel in the
full left position. Turn the ST TRIM knob to adjust the left
end point.
5 right Steering end Point
Hold the steering wheel in the full
right position. Turn the ST TRIM knob to adjust the right end
point. Return the steering wheel to the center position.
6
Power off the transmitter to save the travel adjust settings.
ChanGInG The TraVel adjusT seTTInGs
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
/ / / / / / / / / / / / / / / / / / / / / / / / / / / /
1
Insert a Bind Plug in the BIND port on the receiver.
2
Insert a second Bing Plug in the DISABLE port on
the receiver.
3
Connect a fully charged battery pack to the ESC.
4
Power on the ESC. The orange LED flashes, indicating
the receiver is in bind mode.
5
Center the ST TRIM and TH TRIM dials on the transmitter.
6
Press and hold the BIND button while powering on
the transmitter.
7
Release the BIND button when the orange LED slowly
flashes. The transmitter and receiver are linked when
the orange LED is solid.
8
Pull the transmitter trigger to Full Throttle.
9
Push the transmitter trigger to Full Brake, then return
the trigger to center.
10
Turn the transmitter steering wheel to Full Right.
11
Turn the transmitter steering wheel to Full Left, then return
the steering wheel to center. The orange LED flashes once.
12
Remove the Bind Plugs, then power off the receiver to
save the settings.
13
Power off the transmitter.
dIsablInG The sTabIlITy assIsT FunCTIon
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
/ / / / / / / / / / / / / / / / / / / / / / / / / /
The minimum Travel is 75%,
and the Maximum travel is 150%.
ImporTanT:
If the travel is changed
on the DX2E, you must rebind and
calibrate the SRS4200.
If you participate in organized racing,
you may be required to turn Stability
Assist off.
ImporTanT:
You must calibrate
the receiver each time it is placed
in bind mode.
To activate AVC, see the steps in
“Calibrating the Receiver”.
