14
oPeration
led StatuS
waiting for throttle position
position set
neutral
Flashing Green
Solid Green (1 second)
forward
Flashing Red
Solid Red (1 second)
full Brake/reverse
Solid Red
/
Flashing Green
Solid Green (1 second) followed by Red and Green flashing 3x
c change eSc running Mode: forward/
reverse with Smart Brake forward
only with Brake or crawler Mode
•
The green LED will indicate the
currently selected ESC running
mode for 4 seconds:
-
Green
Forward/Reverse
LED Solid
with Smart Brake
-
Green LED
Forward Only
Flashing
with Brake
-
Red + Green
LED Solid
Crawler Mode*
•
Move the throttle trigger to full throttle
within the 4 seconds to select the next
ESC mode. A beep will sound and the
green LED will indicate the new ESC
running mode.
•
To select the next mode, repeat the
step above within 4 seconds of the
beep.
•
Both red and green LEDs will flash
3 times with 3 beeps.
•
Power OFF the ESC and then power on
the ESC to return to normal operation
•
At any time that the ESC is powered
and the transmitter is at neutral, the
green LED will indicate the current
running mode:
-
Green
Forward/Reverse
LED Solid
with Smart Brake
-
Green LED
Forward Only
Flashing
with Brake
-
Red + Green
LED Solid
Crawler Mode*
*
noTiCe:
Crawler mode is for use on
rocky surfaces only. Do not use this
mode with your vehicle on any other
surface, especially pavement. Doing
so may damage the vehicle.
SMart Brake
When the throttle is changed from
Forward to Reverse or Reverse to
Forward, the ESC will brake instead
of reversing the motor immediately.
The ESC will remain in brake mode
unless the throttle is returned to the
neutral/stop position for a short time.
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
b transmitter/eSc enpoint calibration
•
After executing the setting task, the
green LED will flash as you release
the throttle trigger to neutral. Once
neutral is reached, a beep will sound
and the green LED will glow solid for
1 second. The red LED will begin
to flash.
•
Move the throttle trigger to full
throttle and hold it until a beep
sounds and the red LED glows
solid for 1 second. Release the
throttle trigger to neutral and the
red LED will glow solid while the
green LED will begin to flash.
•
Move the throttle trigger to full
brake/reverse and hold until a
beep sounds and the green
LED glows solid.
•
Release the throttle trigger to
neutral. Both red and green LEDs
will flash 3 times with 3 beeps.
•
Power OFF the ESC and then
power ON the ESC to return
to normal operation.
