14
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
led indicator
oPeration
led StatuS
Sound at PoWer uP
Stop
OFF
Forward
Blinks
Forward (full speed)
Solid
Reverse
Blinks
Brake
Blinks
Brake (full brake)
Solid
Ni-MH/Ni-Cd Battery
1 Short Beep
2S Li-Po Battery
2 Short Beeps
ESC Ready
1 Long Beep
Battery Low Voltage
Blinks
Overheat
Blinks
ProGraMMinG the eSc
The ESC comes with two jumpers pre-installed in the
REV: ON and BATT: Ni-MH configurations. To disable reverse
or change the battery type to Li-Po, disconnect the jumper
from the default port and connect it to the desired port. Power
off the ESC, then power it on again. If the jumpers are lost or
not installed, the ESC will default to REV: ON and BATT: Li-Po.
