background image

EN

limited warranty

  / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /

What thiS Warranty coVerS

Horizon Hobby, Inc. (“Horizon”) warrants to the original 

purchaser that the product purchased (the “Product”) 

will be free from defects in materials and workmanship 

at the date of purchase.  

What iS not coVered

This warranty is not transferable and does not cover (i) 

cosmetic damage, (ii) damage due to acts of God, acci-

dent, misuse, abuse, negligence, commercial use, or due 

to improper use, installation, operation or maintenance, 

(iii) modification of or to any part of the Product, (iv) at-

tempted service by anyone other than a Horizon Hobby 

authorized service center, (v) Product not purchased 

from an authorized Horizon dealer, or (vi) Product not 

compliant with applicable technical regulations. 
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORI-

ZON MAKES NO OTHER WARRANTY OR REPRESENTA-

TION, AND HEREBY DISCLAIMS ANY AND ALL IMPLIED 

WARRANTIES, INCLUDING, WITHOUT LIMITATION, 

THE IMPLIED WARRANTIES OF NON-INFRINGEMENT, 

MERCHANTABILITY AND FITNESS FOR A PARTICULAR 

PURPOSE. THE PURCHASER ACKNOWLEDGES THAT 

THEY ALONE HAVE DETERMINED THAT THE PRODUCT 

WILL SUITABLY MEET THE REQUIREMENTS OF THE 

PURCHASER’S INTENDED USE.

PurchaSer’S reMedy

Horizon’s sole obligation and purchaser’s sole and 

exclusive remedy shall be that Horizon will, at its option, 

either (i) service, or (ii) replace, any Product determined 

by Horizon to be defective. Horizon reserves the right 

to inspect any and all Product(s) involved in a warranty 

claim. Service or replacement decisions are at the sole 

discretion of Horizon. Proof of purchase is required for  

all warranty claims.  
SERVICE OR REPLACEMENT AS PROVIDED UNDER  

THIS WARRANTY IS THE PURCHASER’S SOLE AND 

EXCLUSIVE REMEDY.

ProBleM

PoSSiBle cauSe

Solution

Won’t turn in  

one direction

 

»

Servo gears damaged

 

»

Replace servo

Motor does not run 

 

»

Motor plugs loose

 

»

Motor wire broken

 

»

ESC damaged

 

»

Plug in completely

 

»

Repair or replace as needed

 

»

Contact Horizon Hobby Product Support

ESC gets hot

 

»

Motor over-geared

 

»

Driveline bound up

 

»

Use smaller pinion or larger spur gear on motor

 

»

Check wheels, suspension and transmission for binding

Poor run time and/or 

sluggish acceleration

 

»

Ni-MH pack not fully charged

 

»

Charger not allowing full charge

 

»

Slipper slipping too much 

 

»

Motor worn out

 

»

Driveline bound up

 

»

Recharge battery

 

»

Try another charger

 

»

Check/adjust slipper

 

»

Replace motor

 

»

Check wheels, transmission for binding

Poor range  

and/or glitching

 

»

Transmitter batteries low

 

»

Vehicle battery low

 

»

Loose plugs or wires 

 

»

Check and replace

 

»

Recharge or replace

 

»

Check all wire connections and plugs

Slipper won’t adjust

 

»

Spur gear face worn out

 

»

Replace spur gear and adjust slipper

/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /

Summary of Contents for TWIN HAMMERS KIT


















Reviews: