Warnings
To prevent damage to your Vaultek
®
unit or injury to yourself or to others, read the following safety precautions
before using this unit.
03 Vaultek
®
DO NOT
PLACE OR STORE THE BACKUP KEYS INSIDE
THE SAFE AT ANY TIME. IF THE BATTERY FAILS, YOU WILL
BE UNABLE TO OPEN THE SAFE.
DO NOT
expose to extreme heat or cold. Battery power
may be affected.
DO NOT
store loaded guns in this unit. Firearms are
serious in nature and must be handled with respect.
Store responsibly.
DO NOT
get fingerprint sensor wet.
ALWAYS
check to make sure door has latched
when closing; door requires a firm press and locks
automatically.
Be sure and follow all local and state firearm laws.
DO NOT
operate a firearm without proper training and
experience.
Check page 13 and 14 for Nano Key warnings.
Disclaimers:
NEITHER SELLER NOR MANUFACTURER SHALL BE LIABLE FOR UNAUTHORIZED ACCESS, ANY INJURY, LOSS OR
DAMAGE TO PERSONAL PROPERTY DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OF, OR THE INABILITY
TO USE THE VAULTEK
®
SAFE.
THE USER SHALL DETERMINE THE SUITABILITY OF THE VAULTEK
®
SAFE BEFORE THE INTENDED USE AND USER
ASSUMES ALL RISK AND LIABILITY WHATSOEVER IN CONNECTION THEREWITH. VAULTEK
®
SAFES ARE NOT
INTENDED TO PROTECT AGAINST ENVIRONMENTAL HAZARDS INCLUDING FIRE AND WATER.
The Bluetooth
®
word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of
such marks by Vaultek Safe, Inc. is under license.
Battery:
Installation
Your safe uses a 3.7V 18650 rechargeable lithium-ion with a flat top. A minimum
2000 mAh capacity is required, however 2200 mAh or higher can be used to
increase operation time.
Battery Operation:
Battery Installation
To get started open the safe using one of your backup keys via the keyhole at the
back of the safe. Open keyhole cover, push key in and rotate key clockwise to open
the safe.
Locate the battery door and open by depressing the tab near the front of the cover,
allowing the door to fold down (Figure A/B).
Snap the battery (included in accessory box) into the battery door (Figure B/C). The
battery door has molded snaps for the battery to clip into. Note that your Vaultek
®
safe automatically detects the polarity of the battery and can be snapped in either
direction.
Tip!
Make sure to push battery to back of the battery door allowing the door to
close properly.
Close the battery door. When the battery door is closed you will hear a short
welcome tone and the keypad will light up.
IMPORTANT!
First time users should change the default code immediately after
installing the battery to prevent unauthorized access to your safe.
IMPORTANT!
Register your safe online. Registration provides many benefits
including three year warranty, technical support and ordering replacement keys
should you misplace them. Go to vaulteksafe.com/support/ then select Product
Registration.
04 Vaultek
®
A
C
B
