Storage
59
Pull up license plate holder and fully
insert the holder supports into the
retainers.
Install the tail lamps
First remove the rear (1), then the
front (2) tail lamp from the recesses.
Open out the bulb holder on the back
of the tail lamp completely.
Push the clamping lever and push the
bulb holder into the retainer until it hits
the stop.
Perform this procedure for both tail
lamps.
Check the cable and lamp position to
make sure these are correctly
installed and are securely located.
Summary of Contents for Antara 2014
