Instruments and controls
95
To charge a mobile device:
1. Remove all objects from the
charging slot otherwise the
system may not charge.
2. Insert the mobile device with the
display facing to the rear in the
charging slot. Charging status is
indicated in the Info display
0
and
shows if mobile device is properly
positioned.
If
0
is not displayed, remove mobile
device from the slot. Turn mobile
device 180 degrees and wait three
seconds before inserting mobile
device again.
PMA or Qi compatible mobile devices
can be charged inductively.
A back cover with an integrated coil
(e.g. Samsung 4 and 5) or a jacket
(e.g. some iPhone models) may be
required to charge a mobile device
The mobile device must be smaller
than 8 cm in width and 15 cm in length
to fit into the charging device.
Protective cover for the mobile phone
could have impact on the inductive
charging.
Ashtrays
Caution
To be used only for ash and not for
combustible rubbish.
A portable ashtray can be placed in
the cupholders.
Summary of Contents for INSIGNIA 2017
