background image

3

Vax Careline

0870 606 1248

safety information

2. Safety Information

For Household Use Only

When using the carpet washer, basic safety precautions
should always be observed, including the following:

1.

Do not leave the carpet washer unattended when
plugged in. Unplug it from socket when not in use.

2.

To prevent electric shock do not use outdoors.

3.

Not to be used as a toy. Close supervision is
necessary when used by or near children or the
infirm.

4.

Use only as described in this manual.

5.

The appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.

6.

Do not use with a damaged cord or plug. If the
supply cord and/or plug is damaged, they must be
replaced by the manufacturer, a Vax Service Agent
or similarly qualified persons in order to avoid hazard.

7.

Do not pull or carry by the cord, use the cord as a
handle, allow the cord to come into contact with
hot or sharp surfaces or close a door on the cord.

8.

Do not unplug by pulling on the cord.

9.

Do not handle the plug or carpet washer with wet
hands.

10. Do not put any objects into openings or operate

with openings blocked, keep them free of anything
that may reduce airflow.

11. Keep hair, loose clothing, fingers and all parts of

the body away from openings and moving parts.

12. Do not use the carpet washer on any glowing,

burning or smoking particles.

13. Do not use without the solution tank and dirty

water tank in place.

14. Turn off all controls before unplugging.

15. Do not use to pick up flammable or combustible

liquids such as petrol, or use in areas where they
may be present.

16. Keep the carpet washer on the floor.

17. Do not use an extension cord.

18. Do not attempt to remove blockages with sharp

objects as they may cause damage.

19. Store indoors put away after use to prevent tripping

accidents.

20. Using improper voltage may result in damage to the

motor and possible injury to the user. The correct
voltage is listed on the rating label.

21. A hazard may occur if the carpet washer runs over

the power supply cord.

NOTE: Carpets should be dry vacuumed
thoroughly before washing.

NOTE: If the supply cord is damaged, it must
be replaced by the manufacturer, a Vax

service agent or similarly qualified persons in order
to avoid hazard.

NOTE: The carpet washer must be unplugged
from the mains socket outlet after use, and

before cleaning or maintaining the carpet washer.

IMPORTANT: This carpet washer is not
intended for commercial use.

!

!

!

!

Summary of Contents for Centrix 3 series









Reviews: