--- ---
Filling detergent tank
Operation
6
IMPORTANT:
Do not mix Vax detergent with any other cleaning detergent.
This product can be used with or without detergent.
Detergent tank is located in the hose/handle assembly.
Place the hose/handle assembly on a flat
surface. Unscrew the detergent tank cap
by turning anti-clockwise.
Pour 50ml of Vax detergent and 150ml of
water using the measuring jug, into the
detergent tank. Attach the detergent tank
cap and tighten by twisting clockwise.*
50ml detergent plus 150ml water to 1 clean water tank.
Refilling water during operation
Press steam trigger to release pressure.
When tank is under pressure, the safety
pressure indicator (red) will rise above
the surface of the lid.
When the tank is not under pressure,
the indicator will be flush or below the
surface.
NOTE:
Wait 10 minutes until the safety pressure indicator has gone down, which indicates the steamer has cooled. If after this time
the indicator has not fully dropped, release residual steam pressure by pressing steam trigger on handle and then gently pushing
the safety pressure indicator. Slowly unscrew the tank lid anti-clockwise but do not remove. Allow steamer to cool an additional 5
minutes. After you have ensured steamer has cooled and pressure has been released the water tank lid should turn freely to
remove. Remove any remaining water to avoid overfilling. Return to ‘filling clean water tank’.
IMPORTANT:
Turn off the steamer and unplug from electrical socket before filling up the clean water tank.
S6S Home pro steam cleaner UG 28.02.13_User guide 07/03/2013 11:41 Page 6
