11
3 Prior to first use
3
Prior to first use
3.1 Unpacking
1.
Unpack the appliance and its accessories.
2.
Check the contents for completeness and
possible damage (Fig. 1).
3.2 Positioning the docking station
1.
If possible, choose a location where there
is no carpet. The rubber feet will adhere
better to a level surface.
2.
Locate the docking station in close prox-
imity to a mains socket.
3.
Locate the docking station against a wall
or a piece of furniture so it will not be
moved by the robot.
4.
Make sure that there is a space of at least
1 m x 1 m in front of and next to the dock-
ing station (Fig. 5).
5.
Now remove the 4 protective films from
the rubber feet underneath the docking
station (Fig. 6) and position it in a stable
manner.
6.
Have the AC adapter cable placed behind
the station (Fig. 7) so that it does not ob-
struct the robot's ability to dock.
CAUTION:
Keep the packaging for storing the appli-
ance, or for safe transport. Always transport
or ship the appliance in its original packag-
ing to avoid damage.
NOTE:
Contact your dealer if you have found dam-
age resulting from transport.
1 m
1 m
5
6
7
CAUTION:
Rubber may cause unwanted stains or dis-
colouring on certain surfaces such as wood.
Check the manufacturer's recommenda-
tions to avoid damage.
NOTE:
Also remember not to locate the light fence
tower near the docking station. Otherwise
your robot may be impeded from docking to
the station.
12
3 Prior to first use
3.3 Connecting the docking station
1.
Ensure, that the docking station is being
positioned correctly (Fig. 5).
2.
Plug the connector of the AC adapter ca-
ble into the socket on the side of the dock-
ing station (Fig. 8).
3.
Connect the AC adapter plug to the mains
socket.
3.4 Charging the battery pack for the first time
1.
Ensure that the docking station is correctly
positioned and connected,
Z
Chapter 3.3,
"Connecting the docking station"
.
2.
Activate battery pack charging by switch-
ing the toggle switch underneath the robot
to "on" (Fig. 9, "I" position).
3.
Place your robot manually onto the dock-
ing station (Fig. 10).
4.
Watch out that the charging pins of the
docking station and the charging pins on
the bottom of the robot make contact 1
(Fig. 10/1).
- Red LED is lit and blue LED is flashing.
- A short beep occurs.
- If not, it is not correctly positioned.
In that case, try again.
8
WARNING:
Danger of injury! Only use the AC adapter
and docking station supplied with the appli-
ance to charge this equipment.
9
1
10
NOTE:
Before operating your robot for the first
time, charge it. This will help to retain the
battery life.
NOTE:
Battery pack can only be charged if toggle
switch is put into "I" position.
RBNAV1B1_Navigator_Robot_UG_Amd_190216.indd 13
19/02/2016 10:43
