5
Vax Careline
0870 606 1248
operation
4. Operation
IMPORTANT:
Operate carpet cleaning machine only
at voltage specified on data plate on back of cleaner.
On/Off Pedal
Plug carpet cleaning machine into a properly grounded
outlet. Step on pedal to turn carpet cleaning machine on.
Step on pedal again to turn carpet cleaning machine off.
Handle Release Pedal
Step on pedal to lower handle to operating position.
Handle does not lock into a single position but “floats” to
allow convenient operation (Fig.4/2).
Automatic Shut-off
When the recovery tank (lower tank) is full, the automatic
“shutoff” mechanism will shut off the carpet cleaning
machine suction.
When this happens, the red float disk will rise to the top of
the recovery tank lid (Fig.4/3). The carpet cleaning
machine will no longer pick up dirty solution and the motor
sound will become noticeably higher in pitch.
When this happens, turn carpet cleaning machine off and
empty recovery tank before continuing use.
Check clean solution tank also; it may need to be refilled.
NOTE:
Check the recovery tank often. Empty tank when it
appears full even if the automatic shut-off has not
engaged.
To transport
NOTE:
Turn carpet cleaning machine off before
transporting.
To move your carpet cleaning machine from room to room,
put handle in upright and locked position, tilt carpet cleaning
machine back on wheels, and push forward (Fig.4/4).
The carpet cleaning machine may also be lifted by placing
ahand under the upper clean solution tank handle as
shown (Fig.4/5).
Filling the Clean Solution Tank (upper tank)
The clean solution tank holds the cleaning solution that is
to be dispersed onto the surface to be cleaned.
IMPORTANT:
Disconnect carpet cleaning machine
from electrical outlet.
Place handle in the upright, locked position. To remove
tank, press down on handle and pull forward (Fig.4/6).
Fig.4/2
Fig.4/3
Fig.4/4
Fig.4/5
Fig.4/1
On/Off
pedal
Float disc
Handle
release
pedal
!
!
V-130 Oasis User Guide v5.qxd:V-130 Oasis User Guide
8/9/08
14:46
Page 5
