www.vax.co.uk
6
operation
Carry tank to a sink. Rotate tank cap counterclockwise and
lift up to remove cap (Fig.4/7).
Turn cap upside down to serve as a measuring cup. Using
cap, measure solution as follows (Fig.4/8).
For carpet and carpeted stairs:
Fill cap to upper “carpet”
fill line with Vax Carpet/Upholstery Solution.
NOTE:
Use only Vax cleaning solutions. They are specially
formulated for use with your carpet cleaning machine.
If rubber ring on cap has displaced, replace it with uneven
side against cap ledge as shown (Fig.4/9).
Replace cap. Rotate cap clockwise until it locks in place.
Cap must be locked in place for proper performance and to
prevent leaking (Fig.4/10).
Position bottom of tank into unit and press on tank handle
to snap tank into place (Fig.4/11).
Emptying the Dirty Water Tank (lower tank)
The recovery tank holds the dirty solution that is picked up
from the carpet.
When the recovery tank is full, the automatic “shut-off”
will engage (see page 6) and the tank must be emptied.
IMPORTANT:
Turn carpet cleaning machine off and
disconnect from electrical outlet.
To prevent possible leaking, remove clean solution tank by
pressing down on tank handle and pulling forward; set
tank aside (do not set tank on furniture) (Fig.4/12).
Fig.4/6
Fig.4/7
Fig.4/8
Fig.4/9
Fig.4/10
Fig.4/11
Tank
handle
Tank
cap
Carpet
Rubber ring
Ledge
!
V-130 Oasis User Guide v5.qxd:V-130 Oasis User Guide
8/9/08
14:46
Page 6
