Vax PowerCompact U85-PC-Be, Let'S Get Started

Getting to know your machine 

Getting started

Assembling your vacuum cleaner

Lift handle up and click into place.

Put dusting brush into dusting  

brush holder with brushes  

facing outwards.

Line up latch on accessory hose, 

push until clicks into place.

Line up TurboTool brushes into 

TurboTool holder, push into place 

until it clicks (some models only).

Push accessory hose into hose 

to machine connector.

Push extension tube and crevice tool 

onto holder.

Before you begin cleaning

CAUTION: 

Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments  

or removing and emptying the dirt container.

Filters require cleaning at least every 3-6 months. If the vacuum cleaner is blocked, switch off and unplug before 

removing the blockage.
When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brushbar height adjuster 

must be set to the highest setting.

IMPORTANT:

 The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does 

overheat the thermostat will automatically turn the vacuum cleaner off. If this happens switch the vacuum cleaner off 

and unplug from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. 

Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the 

filters to fully dry before putting back into the machine).

PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE