Using your machine
Make sure water supply is not
connected. Firmly push the
water hose pipe with suitable
connector onto the water inlet
to lock into position.
Connect water hose pipe to a suitable
water supply and turn water on.
Before plugging the machine in,
press the unlock safety button on
the trigger handle and squeeze the
trigger until water starts to flow
through the nozzle.
CAUTION:
Always use an RCD (Residual Current Device) adaptor when using this pressure washer.
CAUTION:
Don’t leave the pressure washer running when not in use for more than 5 minutes to prevent overheating.
Connect the power cord to the mains
supply via an RCD adaptor.
Push the ‘I’ switch to turn on.
The machine will run for a few
seconds then stop but no water
will be released.
Squeeze the trigger on the trigger
handle to release a high pressured
water jet, and start cleaning.
Push ‘O’ switch to turn off.
Before switching the machine on, the trigger handle must be squeezed to release water and to remove any airlocks in the
machine or pressure hose. Always release any build up pressure in the handle prior to disconnecting the hose.
Don’t aim the pressure washer directly at people, animals, plants,
electrical components, wires or the pressure washer itself.
CAUTION
Whilst firmly pushing the lance into
the trigger handle turn clockwise to
lock into position.
To remove the lance from the trigger
handle firmly push and twist the lance
anti-clockwise. When unlocked pull
to remove.
