14
MAINTENANCE & CLEANING
IMPORTANT:
The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the thermostat will
automatically turn the machine off. Switch off and unplug the machine. Check the machine for blockages and clean the dirty
water tank filter.
CAUTION:
Always switch off and unplug the machine before performing any maintenance/troubleshooting checks.
The dirty water tank is fitted with a float. When the dirty water tank is full or the floorhead is not in contact with the carpet,
the float will activate by shutting off the suction on the machine. This will be noticeable as the motor noise on the machine
will increase. If the float has been activated empty the dirty water tank if it is full. If the dirty water tank is not full turn off the
machine at the power switch and wait for the float to settle before restarting your machine.
Empty and rinse out the clean and dirty water tanks and leave to air dry before replacing.
Do not leave solution stored in the tanks between uses.
To remove the lid, pull to
release the latch and push
down to unhook the clip
from the tank.
Lift the lid to remove.
Hold the dirty water tank
handle and pull to remove.
Emptying and cleaning the dirty water tank
Empty the dirty water
tank over the sink or toilet.
Rinse under warm water
(max 40°C) to remove
dirt/debris.
To replace the lid, fit the
tab on the front of the lid
into the front of the dirty
water tank.
Close the lid. Hook the
bottom of the latch on the
tank and push the top of
the latch up and inwards
until it clicks into place.
To replace the dirty water
tank, push the tank into the
machine until it clicks into
place.
